MG 1/100 Alloy Inner-Frame for MG Freedom Gundam 2.0, MG Providence Gundam & MG Justice Gundam, Point Factory

In fact, this part should be divided into two points. The first is the degree of combination of the Inner-Frame of the point factory itself. After all, alloy / Metal parts exist in the form of separate parts, which need to be assembled later. 

As far as the current samples are concerned, most of them are still ok, but the combination of individual small POMs and alloy / Metal parts is relatively useless, and the others are not bad. 

The second point is the combination of plastic outer armor and alloy / Metal Inner-Frame. The whole process can basically achieve perfect matching and perfect combination without modification or modification. Basically it's smooth. However, because only the original MG Freedom 2.0 is currently in hand for testing, it is unknown whether the Inner-Frame will perform the same when applied to the Daban MG Freedom. The Inner-Frame structure itself is the same, it can definitely be used, but The relative combination degree or tightness problem, for Daban kits, this is bound to exist, and needs to be overcome manually.

This thing itself appears because these units of the germline are large backpacks, and the strength of the plastic Inner-Frame is not enough to support it perfectly, which leads to the occurrence of various cartilage and unstable standing, so the necessity of the metal Inner-Frame is It is very prominent, and the point factory is mainly based on the combined structure of alloy / Metal parts and POM (commonly known as Saigang) parts, so the overall stability, support and even durability are relatively guaranteed. From the pictures and The effect of the display can be seen that after installing the alloy / Metal Inner-Frame, the weight and the overall stability of the model kit are improved, and the effect is very obvious.

The Point Factory also ingeniously made a set of special alloy / Metal antennas for players to replace, and from the current replacement effect, the effect is improved, so that the stability of the kit is improved. At the same time, it can also improve the appearance a little, which is indeed quite intimate. 

However, due to the metal antenna, the parts are not handled so well, and some small roughness and coating problems still exist.

This Point Factory MG 1/100 Alloy Inner-Frame for MG Freedom Gundam 2.0, MG Providence Gundam & MG Justice Gundam is undoubtedly a good product. Although there are still some flaws, the flaws do not hide the flaws. 

In terms of the effect and experience of the original product, it is indeed much better than the plastic Inner-Frame. It can be said to be a stable happiness. The price of about USD 20 can be a small upgrade to the original product, and the advantages brought by it are indeed quite cost-effective.