REVIEW ENTRY GRADE 1/144 RX-93ff ν Gundam, Gundam Base Limited

This is review of assembly plastic model kit Gunpla EG 1/144 RX-93ff Nu Gundam from Gundam Side-F Fukuoka series.

ENTRY GRADE 1/144 RX-93ff ν Gundam Review

The item is addicted to the tilt angle that is reminiscent of a statue! cool! The pose of the statue can be reproduced by attaching the flat parts.

The appeal of the plastic model is that you can see it from various angles on your desktop. From the top with a bird's-eye view. In this way, you can easily enjoy a drone-like perspective that is difficult to do with a full-scale statue.

It is an angle where you can fully enjoy the long range fin funnel that is the centerpiece of this item. When you look into it from below, you can feel the huge feeling of a statue.

A close-up of the long range fin funnel. The development gimmick that I am interested in later! The upper body is up. The colorful emblem is reproduced with a marking sticker.

The emblem on the right shoulder is behind. The waist line is also reproduced with a sticker. The legs where the emblem shines again. The backpack comes with new joint parts for long range fin funnels.

Since normal joint parts are also included as surplus parts, you can also attach the fin funnel of "HGUC 1/144 ν Gundam". Comparison with the separately sold "ENTRY GRADE 1/144 ν Gundam". Even if the parts are the same type, you can see that the impression changes greatly depending on the coloring!

Attached joint parts and wrist parts. These parts are recombined to reproduce the firing state and arm wearing state. This is a new runner that makes up the long range fin funnel.

The detailing is also delicate! This is the attached marking sticker. Blue and red lines are used to supplement the long range fin funnel coloring. By the way, the setting of "RX-93ff ν Gundam" is also described in the manual. This is a nice point.

Let's take a closer look at the long range fin funnel from here. The blue part on the top surface is color-coded with a sticker. The base part is packed with information. It is a very complicated surface structure.

The back side. The red line in the center is reproduced with a sticker. We will introduce the long-awaited development gimmick to the long range fin funnel launch state. First, pull out the center block. And replace the joint parts. This will leave the beam launch part open.

If you insert this into the main body again, the firing state is completed. The atmosphere is a bit different from the standing image! The long range fin funnel that has been launched can be turned forward as shown in the photo by changing the joint.

It is also possible to put on the arm as shown in the picture by using a special joint. And posing. This is a pleasure unique to plastic models that cannot be done with a standing statue!